I wondered why I hadn't seen this done more often, but I figured it would be pretty simple.
First version, VERY rough settings, more for me to see if it would work. Also the pla had been sitting out for 2 years so it was perfect for prototypes.
![](https://i.imgur.com/w2h1Qwg.jpg)
Found out I made a spot WAY too thin! And beefed it up to try it out.
![](https://i.imgur.com/5zUhFaU.jpg)
It was way to wobbly and flexible, so I redesigned it a little. Which worked a lot better
![](https://i.imgur.com/V3etpR7.jpg)
Some final tweaks and more printing and I have this, which is far too much fun and probably much too loud(yea right).
It works great with the Tech-T Shaft kit or just the stock 3-Way with the bend cut off(there's a set screw for this purpose).
![](https://i.imgur.com/3DEHFOf.jpg)
First version, VERY rough settings, more for me to see if it would work. Also the pla had been sitting out for 2 years so it was perfect for prototypes.
![](https://i.imgur.com/w2h1Qwg.jpg)
Found out I made a spot WAY too thin! And beefed it up to try it out.
![](https://i.imgur.com/5zUhFaU.jpg)
It was way to wobbly and flexible, so I redesigned it a little. Which worked a lot better
![](https://i.imgur.com/V3etpR7.jpg)
Some final tweaks and more printing and I have this, which is far too much fun and probably much too loud(yea right).
It works great with the Tech-T Shaft kit or just the stock 3-Way with the bend cut off(there's a set screw for this purpose).
![](https://i.imgur.com/3DEHFOf.jpg)
![](https://i.imgur.com/nnLwA1J.jpg)
Comment