POP Contest- SplatMaster?

[ArmyOfOne]

I've had an extra set of splatmaters shells and an idea laying around for quite a while. The plan is to shove some spare nelson internals into the splarmater shells.

[ArmyOfOne]

Off to a good start. The valve chamber can be reused and I found a powertube that fits in the original valve nut. I also found a nice bore drop front bolt and random hammer for now. I turned down a .682 Pathogen barrel to fit in the lower tube.

[Rainmaker]

Nice! Looking good

[moving_target]

nice. looking forward to watching it

[ArmyOfOne]

I found a piece of brass tube that fits perfectly over the powertube and pressed nicely into the front bolt. I tapered the tube towards the hammer and tapered the inner diameter of the hammer so the front bolt picks the hammer up smoothly on the pump back. This results in a very smooth return stroke and should give good gas effiency. I also figured out the trigger group and made a barrel tip to clean the front end up a bit. I have a few more barrel fronts that may be made into a loudener and a rain cover.

[Brokeass_baller]

Dude. This is awesome.

[MrKittyCatMeowFace]

Very nice. Want

[ArmyOfOne]

Cleaned everything up and bored out a spare sheridan pump handle. Used some spare brass to make a pump arm.

[Alexndl]

Nice work
I want to make the same thing now...
Bolt action would be cool too

[Arthur]

That’s awesome, nice work dude.

[Chuck E Ducky]

This is super cool! Sharpie Tiger stripe it! Or paint it.

[ArmyOfOne]

Sharpie tiger stripe would be sweet

[RuleOfSines]

I really like that, resembles a SideKick now.

[ArmyOfOne]

Id forgotten about the SideKick. It does have a similar look

[Cdn_Cuda]

Awesome build!