45° Elbow Clamping Feedneck

[devilzcall]

I don't know if any exist, but i drew one up in a hazy flash and plan on getting it SLS Printed in PA12 Nylon by jlc. Anyone else interested?
I will have to buy the hardware in multiples of 10 Anyways.


I could probably engineer this into a product, but if i'm just doing it for me i'll stop here

Are there significan size differences in 45° Feed Tubes between cockers, mags, spyders, etc.?
I can also make a mirrored version at near 0 extra cost. Man I love 3D Printing.

[iamthelazerviking]

Very cool

[SETHZILLA!]

I'll buy a few

Sent from my SM-S921U using Tapatalk

[Moodog]

I would be interested in a lot of these if you could make the marker side of the feedneck fit a Line SI bushmaster.

[Jordan]

Are there significan size differences in 45° Feed Tubes between cockers, mags, spyders, etc.?
I can also make a mirrored version at near 0 extra cost. Man I love 3D Printing.

Diameter wise, nearly all sidefeed markers are 7/8" OD, with the rest being 1" OD.

Cockers and Mags are 7/8".

[Cal440]

Would be interested also

[Hellion360]

They look solid.
A nice low RF adapter that clamps well would be solid.

I am interested depending on price.

[NONOBLITUS]

These are cool , I would be in for a couple