Mechanical “Bolt” Action Evil Omen

[Cdn_Cuda]

With coaching season winding down, got a hankering for some tinkering. Starting point is an Evil Omen. Which I’m pretty sure cost less than $100 USD. The only legit paintball parts I used were a Hybrid reg and macro line, both out of the tool box. Rest of the parts were scavenged/repurposed. Used a dremel to cut some metal, a vice to make some bends.

[Cdn_Cuda]

Trigger assembly that trips the sear:



Liberal use of springs and screws. Short trigger pull.

[OrangeF742]

Nice, do you have video of it shooting?

[Cdn_Cuda]

I don’t but likely can! I’ll see if I can do one today.

[Cdn_Cuda]

OrangeF742 Shooting video! The level action made it double fed so I took that off and manually cocked it.

https://www.reddit.com/r/paintball/s/1wCROJDT06

[Axel]

Reddit? That's a ban 😜

Cool build!

[Cdn_Cuda]

Much, much easier to post videos on Reddit than on here. Hated using YouTube the posting a link. Was actually the reason I started using Reddit in the first place.

[kawzy]

That is such a cool build! I completely forgot about the omen, kinda always wanted one but only because I was an evil fanboy 😎

[Chuck E Ducky]

You should put a Phantom over barrel handle on that barrel and make it a pump with some sort of linkage at the back.

[Cdn_Cuda]

Would likely be the easiest way to pump it. I know a few people with 3D printers I may have to suck up to.

[Spaghetti Overdrive]

Cdn_Cuda - I might know a couple hobby machinists and 3d printers who'd be happy to do it at cost for me if you'd like me to extend a request.

[Cdn_Cuda]

@Spaghetti Overtdrive. Thank you for the offer! At this point it’s a stalled project but if I get back into it I’ll let you know!