field marshall /warmachine revolver part thingie?

[mueller]

https://www.ebay.com/itm/306039043007

what is this??

[RuleOfSines]

Clone of the ACI Turret, it’s a wee bit jank. It’s supposed to have a shoulder pad on there.

Edit: That price seems a bit high for a clone, but it is itself fairly vintage at this point. Don’t buy it expecting to get much use though.

[Trbo323]

Yeah that seems high to me for the condition it's in

Sent from my motorola edge 2024 using Tapatalk

[Chuck E Ducky]

Rust on them bolts tells me the ball bearings and springs that make these functional are probably not operating properly.

No but stock, unknown condition and rust. I have seen the clones and original go for a good amount but that’s a lot for the work required to make it function.

If anyone buys this take it apart inside a 5 gal bucket they come apart like a hand grenade. I purchased one new when they blew out the last of the stock on them. Took a while to get functional out of the box. The outside guide plates have to be set just right and thread locked in place. To lose it won’t orientate to tight it binds and tweaks it out of square. The original ones were a nightmare to work on to.

Also for thoes that don’t know The drum dose not ratchet you have to manually degas roll the drum then puts the lever down.

The ICD type single 12g are much faster that’s why I sold mine. It’s more novelty than functional. At least a 6pack kicks and feeds the next one quickly.

[Painthappy]

Too bad it doesn't have the shoulder stock. It is just an aci clone but you don't see either showing up anymore due to you hoarders. Yeah you... I'm talking to you.

[Pyrate Jim]

One. I have one of the ACI. Don't blame me.

[Chuck E Ducky]

Would not be hard to make it’s just a round aluminum piece with a hole drilled in it and some flat bar rounded over and some sticky foam.