Vintage Brass

[Walker]

https://www.ebay.com/itm/28525520149...IAAOSw84tkST~v

https://www.ebay.com/itm/28525520813...wAAOSwAXxkSUB9

[BrickHaus]

Id buy the 2nd one just for the bolt.

[chplnstone]

I was hoping these would stay off the radar :-P

[chplnstone]

so I won one of them (with the intention of selling off the frame/autotrigger bits and stock, then use the body for another lever build...), and just my luck it's cut for a j-hook type quicksilver leverchanger that was not included. looking back at the other auction it likely had one too. in asking the seller if he happens to still have them he said was given the markers by a buddy and 'knows nothing about them'. he says he'll ask the previous owner about them this weekend but is doubtful, any chance anyone has a spare jzhook quicksilver laying around? otherwise I'll likely have to just take the loss, sweat the valve core out, and start over with fresh brass

[AnarchicArctic]

Oof…good luck

[k_obeastly]

should not be hard to make

[chplnstone]

I could fabricate one, but it would be considerably easier to simply replace the bottom tube. I've alrrady sold off the j-hook leverchanger markers I've had, though I still have a p-series quicksilver to use as a model if need be, trickiest part is fabricating the lever itself

[B-three]

Nice grabs