I Have No Idea What I'm Doing...

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Painthappy
    Administrator
    • Jul 2020
    • 2666
    • New Boston, NH

    #1

    I Have No Idea What I'm Doing...

    55664840833_b4690b1df0_k.jpg

    I recently purchased a Ms PacMan from 1981 for the wife. She used to love playing the game. Well, the cabinet was in my garage for sometime and I finally moved it inside. Something fell on the transformer board and shorted two fuses, which melted some fingers on the board.

    I can't solder for crap. Nevermind fine electronics. Nevermind vintage electronics.

    I figured if I was to buy a new board, I might as well work on this one. I purchased some copper tape, cleaned up the burned fingers, tinned it, used wicking tape to clean it up the best I could. It's a total amateur job but.... I tested the continuity and everything seems to work out.

    Waiting for a Buss 2 amp fuse to show up tomorrow before I can fully test it.

    Fingers crossed.
    I am the admin...
  • scottieb
    Member since 2004
    • Jul 2020
    • 4264
    • Lincoln, Nebraska

    #2
    Fingers crossed with you. I hope you can get this up and running. It's a very cool thing to do.
    FEEDBACK - https://www.mcarterbrown.com/forum/b...k-for-scottieb

    Comment

    • OpusX
      Still pumpin'
      • Jul 2020
      • 1423
      • KCMO

      #3
      Doesnt look too bad and should get the job done.

      Since the main board connetor tabs werent lifted, using magnet wire to bridge the points and then covering with UV cure solder mask would be the super solid fix.
      Velcor will save us...

      Current MCB Feedback : https://www.mcarterbrown.com/forum/b...opusx-feedback
      Legacy MCB Feedback (Wayback Machine)

      Comment

      • TencenT
        Postin
        • Mar 2026
        • 148
        • Henderson, NV

        #4
        I've found soldering to be like welding, even if you're doing a more than passable job everyone on the internet wants tell you how you're going to send the entire universe into a black hole for how poor a job you've done.

        Looks good, seems you're just fine at solder work.
        Feedback - SnapshotPB

        Comment

        • XEMON
          Frenchy is here!
          • Jul 2020
          • 3019
          • Nor Cal

          #5
          feel free to post or reach out directly if you have any questions, i love old electronics 😊1
          Love my brass ... Love my SSR ... Hard choices ...

          XEMON's phantom double sided feed
          Keep your ATS going: Project rATS 2.0
          My Feedback

          Comment


          • Painthappy
            Painthappy commented
            Editing a comment
            That is fantastic to know!
        • THE SHOOTIST
          Rockin and Cockin
          • Jul 2020
          • 92

          #6
          You know what us Old School Electricians say: "When in doubt, jump it out."

          Comment


          • XEMON
            XEMON commented
            Editing a comment
            That is also the fastest way to release the magic smoke
        Working...