Just got my new resurrection ram from action village's ebay but when it's fully screwed together the ports aren't even close to parallel. Is that normal?
-
-
Mine is slightly off, but not that much.Attached Files -
-
Yes, It has to do with the differences in ano thickness.BeardedWorks.com (Your Inception Designs and Shocktech Dealer)
BW Youtube
BW Ebay
BW Email
I buy Automags and Mag Parts also.Comment
-
Velcor will save us...
Current MCB Feedback : https://www.mcarterbrown.com/forum/b...opusx-feedback
Legacy MCB Feedback (Wayback Machine)Comment
-
I don't think the Ano is to blame. Ano layers are ~0.0007-0.0015" for type 2 Ano which I believe this is. Let's give it +-0.003" for difference in material removed during etching. So adding up those up (assuming my understanding of tolerance stacking is correct) the Ano should at most be responsible for ~0.0067" out from where the parts were before Ano. I don't think that is enough to accommodate the barbs being 1/8th of a turn from each other.Comment
-
So take off the body and sand down the end of it a little until it is on all the way
Sent from my motorola edge 5G UW (2021) using Tapatalk
I use Tapatalk which does NOT display comments. If you want me to see it, make it a post not a comment.
Feedback
https://www.mcarterbrown.com/forum/b...323-s-feedbackComment
Comment