Hey, I am new to here so please forgive me if I make a mistake against the rules. I was wondering if it might be possible to convert a shoe box shocker from electric to mechanical. If it is possible is there a guide or way, I can do it? I have a shoe box shocker that I would want to either turn mechanical or at least try too.
-
-
Might be a bit tricky as these have 2 solenoids -
Possible? I don't see why not
Easy? Hell no
I'm true MCB fashion? Hell yes
Since the whole dump chamber is emptied each shot there's not really any dwell considerations to worry about
Sent from my motorola edge 5G UW (2021) using Tapatalk
I use Tapatalk which does NOT display comments. If you want me to see it, make it a post not a comment.
Feedback
https://www.mcarterbrown.com/forum/b...323-s-feedbackComment
-
At what pressure are those solenoid running at?💀Team Ragnastock💀Comment
-
I use Tapatalk which does NOT display comments. If you want me to see it, make it a post not a comment.
Feedback
https://www.mcarterbrown.com/forum/b...323-s-feedbackComment
-
Look like it could be turned into a pump gun (pneumatic assist).
probably the following componecomponentbe used (but it will get expensive and heavy quickly)
Clippard SMAV3 for the firing
and a 4 way valve to reload (pump activating a SMAV 3 piloting a MPA3 on a MAV4)
Jordan used the same component to replace a 4 way solenoid in my Macdev clone
https://www.mcarterbrown.com/forum/p...ech-conversion💀Team Ragnastock💀Comment
-
A 2 stage trigger would be the only way.
A cocker slider type trigger bolted to a piece of flat bar to replace the tray.
Dual cocker 3 ways, one to operate the bolt, the other the valve.
Time it to close bolt, then open valve as trigger guess through the stroke.Comment
Comment