Inception EZ ASA and Braided Hose

[plunderin]

Has anyone here tried to use steel braided air lines with the Inception EZ ASA? I want to try it but I'm not sure if the hex at the end of the line would interfere with the on/off mechanism.

[BrickHaus]

Have you pulled the fitting off of the ez? They are 10-32, not the typical 1/8" npt a steel braid will be.

You would need a custom made brais with a 10-32 on on end, and 1/8 on the other. Then you would have to dust the hex down.

[superman]

Planet Eclipse Pops on/offs are 10-32.
Inception Designs EZ on/offs are 1/8"npt

[BrickHaus]

Superman. My bad. I have both, so I got em mixed up.

[plunderin]

Have you pulled the fitting off of the ez? They are 10-32, not the typical 1/8" npt a steel braid will be.

You would need a custom made brais with a 10-32 on on end, and 1/8 on the other. Then you would have to dust the hex down.

Nope, don't have one on hand, but hearing the threads are different makes it pretty easy to shelve that idea for now 🫤

[Hellion360]

I use one on my mag.
It's 100% good to go.

Inception ASA are 1/8th NPT threaded, the standard. It is Eclipse pops ASA that will not work.

[Chuck E Ducky]

Clean!

[Jordan]

Have you pulled the fitting off of the ez? They are 10-32, not the typical 1/8" npt a steel braid will be.

You would need a custom made brais with a 10-32 on on end, and 1/8 on the other. Then you would have to dust the hex down.

Something like this?

https://mettleairstore.ca/products/1...3deeb181&_ss=r

[SR_matt]

I just got one of these for my cocker build. The front face of it has clearance around where the lever slides around so there shouldn’t be a clearance issue. I am swapping the stock fitting to a numemch one to make everything all pretty and color matched. The stock fitting is a less common looking thread (short and seals with an o ring) but it’s threaded deep to take a standard 1/8.