Looking to get my trilogy feedneck chopped to accept some sort of a clamping feedneck. Who does the best work and what should I expect to pay for something like that?
-
-
Raises hand. I can take care of it If you can get it here early next week. I am moving in a couple weeks and need to take the machines off power.
I have plenty of pictures in the airsmith section as well. I may not be the cheapest, but i would wager i have the fastest turn around time.
https://beardedworks.com/products/fe...ng-empire-spec
Here is what you can expect to happen. https://www.youtube.com/watch?v=9hU8jr8xOHY&t=4s
This was cut on Saturday.
BeardedWorks.com (Your Inception Designs and Shocktech Dealer)
BW Youtube
BW Ebay
BW Email
I buy Automags and Mag Parts also. -
BMC Fabrication has done quite a few for me, maybe 10. Good results.
$30 ea.
superman Also does them, and his work looks good but I haven't used him.Need Inception Designs or Shocktech Products? Let me know!
MCB Feedback --------- MCB Consolidated WTB
old PBN feedbackComment
-
-
I've used both BMC and superman. Beardedworks is definitely the fastest, quality is top notch with both.Comment
-
+1 superman is great to do business with and is great at communicating info for recommended parts and services. Pretty sure that's my Tril Pro in the above comment, it took a little over a week and current cost was $45 + shipping to and from (about $15-20 total).
As he noted in his above comment though, I think his machining capabilities are going to be offline in the near future for some amount of time so that'd be worth discussing .Comment
-
Comment