What is this wire for? A sensor?
-
-
I think that goes to an intelliframe switch -
I think that goes to the shock sensor in the middle of that bracket, senses when the gun is fired and tells it to run. Can also be hooked to the intelliframe switch.Comment
-
Is that a purple warp feed? I'm jealous.Comment
-
As others have stated, the wire can be hooked to an intelliframe switch.
I will point out that it can also be used to connect to any electropneumatic gun board that has a port/header for hopper activation. For example, my Ion has a Virtue OLED board that has a port labeled "RF". It was mean to support an RF transmitter board like this one. I found that if I simply wired up the correct connector to other end of the intellifeed wire, the OLED board reliably activates the Warp Feed.Originally posted by Tom Kaye, in response to FS price critics:
Unfortunately all of you have played the one "speedball" game of paintball for so long you can't conceive of other ways to do this and hence any new ideas seem stupid.
External Ballistics | Rifled VS Smoothbore FS Barrels | My FeedbackComment
-
Can I connect this to a universal t board?Comment
-
I don't know enough about the universal T-board to say for sure or even how but, I suspect it is possible. The original RF link daughterboard I mentioned was designed to take the same signal/pulse as the solenoid or sear tripper.Originally posted by Snowpuff View PostOriginally posted by Tom Kaye, in response to FS price critics:
Unfortunately all of you have played the one "speedball" game of paintball for so long you can't conceive of other ways to do this and hence any new ideas seem stupid.
External Ballistics | Rifled VS Smoothbore FS Barrels | My FeedbackComment
Comment