Ok so I finally get my ram shaft all polished up after putting a small scratch on it while putting my pump arm on all the way and I snap a barb off in the ram back, I went on acp to buy a new back and barb but I see there are 2 thread patterns for them, 10/32 and 6/32, this is a stock chrome STO ram which ram back do I need
-
-
That is referring to the barb thread size. It depends which barb you have.BeardedWorks.com (Your Inception Designs and Shocktech Dealer)
BW Youtube
BW Ebay
BW Email
I buy Automags and Mag Parts also. -
I’d think the larger size flows better.Comment
-
Ok thanks I'ma go with the 10/32 I'm thinking it threaded in crooked and I just didn't catch it cause of the way the threads broke, it's an STO ram so I'm sure that's what it is I'm thinking it's the old brass rams that had the smaller barbs and maybe some others
I have an extraction set but the smallest one I have is a hair to big and no matter if hammering will get it to stay in place so I can actually turn it and I don't own a vice to hold ram
Comment
Comment