Lucky stage 2 ion firing can rear oring size/durometer

[Ramfaux]

Does anyone recall what the oring that goes inside the tail of a lucky stage 2 can is? I've been putting a 012 70 buna because it's all I have that seems to fit but they keep getting cut after a few hundred cycles. Is it metric? Poly? I would rather not keep guessing cause damn this thing is a pain in the ass to keep taking apart and re assembling

[nerdcore]

If it's the same size as the stock can, it'll take 15/70. I don't remember what the Lucky cans looked like.

[Ramfaux]

If it's the same size as the stock can, it'll take 15/70. I don't remember what the Lucky cans looked like.

the lucky cans have a small oring on the inside at the tail that seals the chamber so you don't need a dual tail oring bolt. I think the 15/70 is for the donut on the exterior

[nerdcore]

Well I have good news and bad news. This is a screenshot from wayback machine, and good news is you're using the right size. The bad news is, your dilemma may persist. I'm reading this as an o-ring for both the stage 2, and separately also for their proto matrix bolt.

[Ramfaux]

Cool, I didn't think of checking wayback machine. Sucks that that's what is supposed to be used though, might have to change the can out for a stock one.