Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
I know it's a boring over discussed topic. I want a few parts recreated in steel or aluminum. Small batches preferred. I'm not a 3D printer or fabricator so I need to send someone these pieces to be copied. Also I'm aware that it is not easy peasy, cheap, etcetera. Thanks for any advice
No prints, no kind of data etc. Triggers, Sears and a strange tube. All around 2 to 3 inches in length and diameter. Yeah, I get it - it's tedious and expensive for anyone to do. I need to learn how to do this on my own
Comment