Did WGP or aftermarket ever release a low profile ASA mount or mount to replace the standard ASA with a mount solely for a standard air connection? im looking to hug the body as close as possible with a horizontal air connection.
-
-
Cooper t made an asa that had a side tap to a back bottle.... But I've never seen one outside of product catalogs -
Can you drill and tap it for npt threads?Comment
-
that can be done, and I've considered that but i don't have the means to plug both the holes in the bottom, I'm not sure if I could reasonably drill and tap with close enough proximity to the untapped hole in the bottom and also plug the existing threaded hole. I am hoping to go with an aftermarket route to minimize any permanent modding.
Comment
-
You're talking about the vertical asa right?
Inception Designs has a plate that blocks off the stock vertical asa holes....
https://inceptiondesigns.com/VASA_BL...p/CGP-0077.htm
If it's going on an autococker you can then use the holr on the bottom of the front block. If no front block you'll at least have a replaceable part to mod instead of the body.Comment
-
I may end buying for another project, currently my build is on a pre 2k body.
If the only difference though is the threaded hole then it may be worth getting and molding the body.Comment
-
I went ahead and picked one up. The price is pretty good and mybuild should be transferrable to a 2k+ bodyComment
Comment