3D Printed Reg Seals

[Cdn_Cuda]

Legit, illegit or MC Hammer?

https://www.ebay.ca/itm/175691249503...Bk9SR7rdpMzZZw

Anyone use these?

[RPP]

They work, I've tested similar materials. The largely unknown factor... to me... Is longevity.

[Jsc5150]

Just got some for my etek3.

HPR seat works well, LPR seat seems to work but I need to put a tester on it

[Hellion360]

Personally I haven't tried them, but reg seats are not expensive and I can't imagine a world where these are longer lasting than punched reg seats.
I would pass on them except in an emergency.

BUUUUT I haven't used them.

[Cdn_Cuda]

Issue is getting them in Canada. I can't order a standard reg seat in Canada, or have it shipped from like Autocockerparts.com without additional issues. So these one I can order directly of Ebay and have delivered.

[JohnB]

I have been using the cocking rod seats that seller makes and I like them. I imagine these work too.

[Jordan]

I'll have a look this week and see if I have any ACP reg seats left. If I do you're welcome to them, I'll toss them in the mail.

I don't plan on using them, I only use Stabs on my stuff for the most part.

[Cdn_Cuda]

Thank you!

[Buff_phroggie]

Cdn_Cuda I have used the blue ones for the jackhammer regs (from ANS) that I had to shave down to fit in WGP lpr and hpr. Not sure if ANS is better at getting stuff into Canada

[Cdn_Cuda]

Didn’t realize they would fit. I believe ANS ships to Canada. Just need to use self restraint and not buy anything else from them.

[Buff_phroggie]

They dont tecnically fit. The way I made it work was jamming an allen key in the hole, chucking it in a drill and shaveing it with a nail file until it fit. Hinestly you are pribably better off ordering a sheet of urathane, and the right holepunch

[cdtrix]

do you really need the bumps on the reg seal?

I have 95A TPU I can print simple pucks out of it.

I'm currently using one i made for my JT Impulse reg as a reg seat.

I have a karni reg i can test it on. Again, not really sure about longevity but it's a solid TPU pick jammed in a hole.

I'm also in Canada but on the otherside.

[Jsc5150]

Welp threw my etek 3 lpr with 3dprinted seat on a tester, recharge is really bad.

Better than creeping, but I now view these with suspicion

https://youtube.com/shorts/bEhLpYfR-...Z5w8i0EvBXtD0H

[Cdn_Cuda]

Yeah, that's not looking good. Thanks for doing this!