What's the adjustment range on a first gen Gladiator reg?

[Jordan]

I wanted to swap some regs around between guns and have a Gladiator to put on my pump, just not sure if it can go below 200psi comfortably.

[Chuck E Ducky]

MacDev Gladiator in line reg you talking about right?

That should operate all the way down to 100psi if I’m not mistaken. Its range should be about 100-450psi.

Should operate fine at 200.

[Jordan]

MacDev Gladiator in line reg you talking about right?

That should operate all the way down to 100psi if I’m not mistaken. Its range should be about 100-450psi.

Should operate fine at 200.

Yup, inline reg. It's the one Docfire makes the updated reg seat for.

I'm a skoosh under 200 - I'm pretty sure I'm around the 180psi range, I just don't have a gauge low enough at the moment until I find my LPR tester and steal the gauge off of that.

[Chuck E Ducky]

Yeah that should operate just fine for what you need.

[Hellion360]

Yeah that should operate just fine for what you need.

The key word here is should. I have found that many (not all) of the older macdev regs will creep from the lower pressures to 3-400psi+ as the reg seats wear out. You should definitely test your reg with a gauge thoroughly.

The good news is that if your reg does creed the Docfire macdev reg fix is inexpensive and works well. I have tested it in a couple of low pressure (180-200PSI) markers and it works great.

[Jordan]

The key word here is should. I have found that many (not all) of the older macdev regs will creep from the lower pressures to 3-400psi+ as the reg seats wear out. You should definitely test your reg with a gauge thoroughly.

The good news is that if your reg does creed the Docfire macdev reg fix is inexpensive and works well. I have tested it in a couple of low pressure (180-200PSI) markers and it works great.

Yup, already have that upgrade of his installed. It seems rock steady on my Matrix, I just figured I'd swap a few things around.