Is there an inline regulator that you just plop on a remote line or ASA?

[ReconSWS]

Looking for a universal regulator with knob and gauge that will allow me to regulate pressure entering marker. It should be threaded 1/8NPT on both sides, or on side ASA threads.

Reason is, my marker (havoc) is pre-production and has some faults... i.e. there are literally functional milling cuts done after anno on it.

Basically, it can't handle being connected to a full 12oz tank, even through a remote. It can handle a half full 12oz tank, but a full one bursts the o-rings instantly. Very annoying.

[Jordan]

Stabilizer with Rock knob?

[Aperture3D]

Palmer's Pursuit Shop has the widest variety of regulators, iirc the general consensus is they work well with CO2.

https://palmerspursuit.com/collections/regulators-1

[ReconSWS]

I went in for it, assuming the link would be denied!

I've never used a reg in my life... how do you know what pressure you're on if there is no gauge? Is there like an included chart or something lol?

[Aperture3D]

Most of the regulators have 1/4 in NPT threaded holes for gauges, plugs and other fittings. As long as the gauge is on the output side it should be accurate.

[Jordan]

Get a Female Stabilizer with two output ports. The bottle screws into the reg, your remote screws into one of the output ports, and a gauge goes in the other.

[Toestr]

Any reg should work. If you want a knob, just get a thumb screw with the same threads as the adjustment screw.

Sent from my Pixel using Tapatalk

[Aperture3D]

I have been looking at the Palmer's Cart regulator for some testing, but I have search my couch for more change.