Would come as shown without a grip. The dropout valve is Line SI and has been devolumized (interchangeable with a Line SI Lever changer body) and the back bottle valve is unknown (CooperT?). Also includes a spring kit, spare cup seal, Line SI #0 and #6 power tubes (no spare retention nut) and the original thumbscrews. Decent shape player's gun. The body has quite a bit of pump handle (plastic, unknown brand) wear at the front but otherwise just the usual small dings and idiot marks.
Velocity maxes out at mid-low 200s on 12g/bulk CO2/HPA. I tried every spring combo possible (non adjustable hammer). It would likely need a tighter bore barrel and/or heavier hammer. The barrel has mylar detent fingers made by someone on here that stop rollouts and double feeds. The barrel retention thumb screw has also been replaced with a brass one to decrease wear. The safety is non-functional (will fire if on safe). I've replaced the side valve thumb screws with cut down loctited screws to just plug the holes and make valve removal easier.
Any thoughts on value would be appreciated.
Sent from my Pixel 4a using Tapatalk
Velocity maxes out at mid-low 200s on 12g/bulk CO2/HPA. I tried every spring combo possible (non adjustable hammer). It would likely need a tighter bore barrel and/or heavier hammer. The barrel has mylar detent fingers made by someone on here that stop rollouts and double feeds. The barrel retention thumb screw has also been replaced with a brass one to decrease wear. The safety is non-functional (will fire if on safe). I've replaced the side valve thumb screws with cut down loctited screws to just plug the holes and make valve removal easier.
Any thoughts on value would be appreciated.
Sent from my Pixel 4a using Tapatalk