‘99 RF Autococker

[Swedgin!!]

IMG_7175.jpg Hello Experts/Gurus I’m looking for the value on this as a lot. I’m on the fence on selling but extra funds wouldn’t hurt. Decisions decisions. So what’s it worth?
#67353 ‘99 RF, Threaded IVA, 32* body (I’ve been told). I can post more pics if it helps. Yes, Front Block is upside down 🙃

[RedLeaderSB]

Can you take a picture thru the bolt tube with a barrel on front?
On mine the bolt and the barrel are not coincident.

[Swedgin!!]

Yeah I can do that when I get home in a few hours 👍🏾

[Pumpytrilly1]

Please PM me when you figure it out.

Unfortunately right and left feeds don't seem to command as much. I'll let someone comment first.

[Swedgin!!]

IMG_7177.jpg Got home earlier than expected. RedLeaderSB You are correct about the bolt tube and barrel alignment. You can see the lip from the barrel on the right😐

[Pumpytrilly1]

Would make a cool display piece though

[RedLeaderSB]

looks a little better than mine. I used a carter insert barrel with the huge lead in, and mine still squeezes paint to get into the barrel.

[Swedgin!!]

Damn lemons!!

[Jordan]

IMG_7177.jpg Got home earlier than expected. RedLeaderSB You are correct about the bolt tube and barrel alignment. You can see the lip from the barrel on the right😐

There's a lot of Cocker bodies like that... never had a problem with any of mine.

I will note that that's the reason Glenn Palmer used to give for Blazers having slip-fit barrels... easier to machine concentrically.

[Swedgin!!]

Is this common for cocker bodies? This is the only body I’ve have so I can’t compare it with others but thanks for the info 👍🏾

[latches109]

I doubt that the body is the issue, most likely your barrel. If you have a bore gauge, take 4 measurements 90* apart.

[Swedgin!!]

I tried using other barrels this morning out of curiosity and the results were the same. I don’t have a bore gauge to check measurements.

[Swedgin!!]

IMG_7181.gif

[Grendel]

Honestly even if it is off bore slightly it really will not affect your shot from the marker any as the ball is loaded into the barrel by the bolt. So, when the ball is launched it will be going straight down the barrel. The biggest "concern" would be pinching the ball but I don't see that being a big issue. I have always like those bodies so I think $150-$200 is somewhere I would settle on for a price. If I did not have too many projects and it was any other color then red I'd make you an offer.

[Swedgin!!]

Grendel Thank you for replying and Thank you to the others that did as well 🤙 Ask and you shall receive.