vert feed micro emag

[superman]

Need some help pricing this.

It isn't in the best of condition. Frame has a few additional holes. I think someone was going down the pneumag route with this and then changed directions.
2 holes up front above the trigger guard. extra hole behind the trigger.
Foregrip/asa hole on the body is stripped out. I guess i could repair that if someone needed me too.

It does have the emag frame spacer, but not the vanity plate.

[FredMnkyDad10]

I dont need another, no I dont. Not sure on value since the chrome looks pretty rough on both body and frame. Someone would likely want to reano. remove of chrome is expensive and chancing it too. But Since the extra and stripped holes you dont have to feel bad about keeping factory stock. Would also be a good candidate for feedneck mod for those reasons. That is why I also did neck mod on my purple micromag.

Doing pneumag with lpr in battery pack would be very cool.

[Psycho91]

This is perfect for a rat rod type build

[superman]

any ideas on this one?

[Grendel]

Sorry to say but in that condition without the Battery Box $200 would be were I would start. It might help cleaning up the chrome and verdigris. Most of it is there and the mods look like they would cover up well but chrome can be a hard sale and missing the battery box could be a deal breaker for those who want to restore. I like that is is a Vert Feed. Personally I would reverse plate the chrome and get it anodized if the corrosion is not too bad.

[Psycho91]

Could this be made into a mech or is the frame strictly electric

[superman]

Yes it can be mech.

[Psycho91]

Ok thanks, my cocker build is almost done so IV been keeping an eye out for a mag to add to the collection