Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
I'll get some better pictures and a better write up later. I'm mostly looking to either trade for a similar condition mag or do a part for part trade. I'll look at trades for whatever else too.
The valve has had a complete oring rebuild, and has a new reg seat on the way. Will need a new bolt. The spring looks like it might be from a level 10, but it seemed to work fine when I tested it with a fresh bolt and reg seat. The powertube also has the earlier style spring instead of spacer.
The rail, sight rail and VASA all appear to be raw and are marked up (the rail has some especially deep marks). The body, rail and sight rail have been painted at some point was mostly removed by abrasives aside from in the tight spots. Sight rail is also epoxied on.
I also have an AGD bottomline and AA thumper expansion chamber which I could keep, could let go depending.
If you're interested in parting out anything, I'm looking for a valve and a sear, sear pin, and twistlock pin.
I don't need the reg seat, rear half, or on-off... I'd be installing a reg cap and RT on-off and running an external reg.
I'll see if I get any offers in the next week or so and let you know. I know some of the parts like the rail are untradeable and can only really be sold for next to nothing.
Comment