Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The manual says to use Dow55 but I've heard Do33 (light) can be used in if you service the reg on a more regular basis. What do you all use? The performance is unaffected?
55 is very thick and swells o rings (supposedly, I've never actually measured before and after) most Bob long stuff calls for 55 but outside of that there's only a handful of places where it's called out for. There's some specialty applications and custom stuff it can be useful for but as a general rule of thumb, stick to 33. I've even rebuilt Bob long stuff with 33 and it's been fine
Sent from my motorola edge 5G UW (2021) using Tapatalk
I use Tapatalk which does NOT display comments. If you want me to see it, make it a post not a comment.
Just curious if anyone actually followed the instructions. I have actually avoided CP regs until learning all CP products were made in the USA a few months ago. They've been very impressive and wanted to keep it that way. Thanks!
I was considering 55 after a rebuild and 33 afterward. When I spoke with CP about two months ago I was asked to call back when a retired employee was planning to visit. She was the only person knowledge enough about paintball products to answer my very basic questions. My point is... I would not be surprised if the employee who wrote the V3 Inline Regulator manual even knew the difference between Dow 33 and 55
Comment