Welcome to MCB! If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Saw this is a common upgrade to reduce trigger weight so I gave it a try... leak leak leak. I inspected all the o-rings and the pin and everything looks fine. Pop my classic on/off back in and everything is fine. What the heck
Just an update. My problems were either caused by lack of lubrication or the small lower pin o-ring being picky about which side it wanted to face up. Played a few games with it and formed an unpopular opinion...I actually prefer the classic on/off. Heavier pull but it breaks so cleanly...
The RT on/off makes it a little mushy. A lower trigger pull weight is needed for things like E frames because most of the centerflag on/offs are long gone and I don't think that booyeah frames and mako frames even had a lighter on/off. It's hard on those noids.
The thing I used to not like, but now love is the level 10 kit. I thought it was finicky and dumb but after spending enough time with it all the components make sense and tuning it perfectly took me like 2 minutes, and zero chops really does rule.
Comment