Can a classic rail be drilled and tapped for RT sear?
anyone done or had this done.
anyone done or had this done.
-
2 things here.
The bushing in the RT sear does not fit in a mag rail so a bit of milling would need to be done to widen it.
If you could find the exact center of the AM/MM sear pin where you would need to drill the hole for the RT sear pin would be very hard...considering the fact that the hole would need to be drilled right on the angled section of the rail. -
To reduce deflection when drilling you can use green stuff modeling epoxy to create a level platform for the drill bit to drill into. When the epoxy dries it will provide enough rigidity to help prevent deflection when drilling into angled metal. I used to do this when I would drill into metal with a shitty hand drill. Granted the epoxy may char the drill bit tip, as the epoxy material is not designed to be drilled. Clean us using break cleaner, or soak in mineral spirits and scrape away with plastic putty knife.
https://www.dakkadakka.com/wiki/en/D...Q:_Green_StuffComment
-
I'm sure any competent machinist with a milling machine could do it pretty easily. Heck... even I've drilled into sloped surfaces before without a problem. You start with an end mill to flatten it out and then go at it with a drill bit.
The bigger question I have is why? What advantage do you think you will get from switching sears?View my feedback or read about my Virginia woodsball club.
Let me make you something. I build pneumags, auto-response frames, and wooden pill cases.Comment
-
Comment
-
View my feedback or read about my Virginia woodsball club.
Let me make you something. I build pneumags, auto-response frames, and wooden pill cases.Comment
-
View my feedback or read about my Virginia woodsball club.
Let me make you something. I build pneumags, auto-response frames, and wooden pill cases.Comment
-
Comment
-
Yeah. I've seen lots of guys put x-valves on classic mags with the old rails and sears. I've run pneumags with RT valves on a classic AM/MM rail without a problem. In what situation does a classic sear not work? -
Don't get me wrong. I'd much rather have an RT sear. The classic ones are annoying. They always seem to fall out and lose the pin whenever I take apart the mag, so I think the RT sear is far superior due to its "user friendly" design. But functionally I always thought they were exactly the same.
-
Comment