Micromag not firing.

[bladex4]

Hey, have a somewhat strange issue.
It was airing up and firing just fine the other day, but just aired it up and suddenly its not firing.

When aired up, the trigger pin locks forward but when I pull the trigger, the trigger pin kinda just mushes back and doesn't actually set off the bolt.

[superman]

degas it pull the valve out and make sure the bolt is not stuck to the valve.

[bladex4]

Nope, I can pull the bolt off and slide it on the valve easily

[superman]

Is your velocity adjuster backed out?

[bladex4]

No, its screwed in, not all the way, but definitely not backed out

[bladex4]

The first few shots seemed to have bolt stick and then it lead to this. Perhaps an alignment issue?

[superman]

See if your sear rod is loose on your sear and has backed out.

[bladex4]

Nope its not loose, I even push the rod as far as itll got with my fingers and nothin

[bladex4]

Can a low pressure tank cause this? Praying maybe my tanks just messed up, cuz I literally didn't change anything from yesterday and suddenly the marker is acting up. Are level 10s really just this finicky?...

[superman]

How low is the tank pressure? It should be outputting at least 600 to function. Ideal is 800ish.
also pull your bolt off and confirm it will slide into the breach with out issue. I have had to machine some down to fit micro mags in the past.

[capitalpaintball]

Check that your grip panel screws are not to long, they can interfere with the trigger arm.