Duckbill ASA Fitting

[bladex4]

Hey, was wondering if pretty much any duckbill asa will fit onto a classic AGD grip. Was looking to purchase a 32Degrees angled duckbill asa and just wanted to make sure it'd fit okay

[Jonnydread]

I would think so, as long as it mounts flat/flush it should be fine. The AGD rubber grips don't generally protrude enough to cause mounting issues.

[Olsson]

I have some 10-15 classic Automags all fitted with a variety of duckbill ASAs. So far I have never encountered a single duckbill ASA that didn't fit a classic AGD frame, with or without the AGD grips.
I have bought different brands of duckbill ASAs for my Mags without giving it a second thought. I would be greatly surprised if you managed to find a duckbill ASA that didn't fit.

Huge disclaimer though - Spyder ASAs have a differing hole configuration, with the holes offset to the sides. It is very, very noticeable though, and that should be the only differing ASA to my mind.

[bladex4]

Sounds good, thanks for the detailed info!

[Spider!]

I had one ASA that I bought cheap back in the 90's from some place like I&I that was too short on the flat spot to go on a mag/cocker frame.

I ground the corner deeper to fit the frame just right. It eventually became part of a good build.

[Jordan]

Got a couple of those in the past and did the same.

[Olsson]

Interesting, I didn't know that. I'm very much in the camp of "I never saw a duckbill ASA I didn't like."

[Spider!]

I&i used to keep so many goofy parts that I quit ordering anything from them.