This came with a valve I just picked up. After doing some research it looks like this is a pro team bolt that was nitrided. Long story short, are these things worth a shit? The only other bolt I've got laying around is an ANS Venturi.
-
-
I think the general consensus is they're better than nothing, but not as good as a stock AGD bolt. -
Check the leading edge where the sear grabs it and make sure it is not chewed up. These were notorious for wiping out sears hence the nitride coatingComment
-
For Lvl 7 nothing beats the long nose bolt by AGD IMHO.
"When you are asked if you can do a job, tell 'em, 'Certainly I can!' Then get busy and find out how to do it." - Theodore Roosevelt
Feedback Link - https://www.mcarterbrown.com/forum/b...del-s-feedbackComment
-
These are gold bolts, but yours looks worn out at the critical point: the lipMy Old Feedback (300+) https://web.archive.org/web/20180112...-feedback.htmlComment
-
Thanks for the advice. I would definitely throw a stock bolt in it if I had one laying around. I may just use the ANS one for now because I know it works at least.Comment
Comment