Newb Quest: Classic Valve w/ Lvl 10

[Arthur]

I’ve been wanting to build out a classic mag setup. I recently picked up a really nice matching classic valve but it came with a Lvl 10 bolt... When I try to fit a standard classic bolt it won’t fit all the way down the power tube. About a half inch gap or so. Lvl 10 slides on just fine.

Can someone point me in the right direction here? What part(s) would I need to bring this back to a classic bolt setup.

Or should I keep the lvl 10 on there? I thought lvl10 anti-chop only works with xvalves, or am I mistaken. Why else would someone want to put a 10 on a classic. Am I just being too picky?

[Jordan]

Lvl10 works on all Mags. Xvalves just came with it already installed.

If you really want to return it to lvl7, you'll need a lvl7 power tube tip, oring, and spacer to replace the lvl10 components installed in the powertube, as well as a lvl7 bolt.

[Arthur]

Thanks my dude.