Would you feel bad milling this rail for a warp right ule body? I think it's a ptp rail. Not ultra rare but not many.
Attached Files
-
Or I mill just a little bit of the front for center feed body. And the mill another standard rail for warp right body.Attached Files -
-
I'd go for a rail already milled for Warp vs. milling that rail. It has nice pills and is already pre-milled, so it would capture someone's attention in a for-sale thread. Talk to superman , he most likely has some already warp-milled rails in his shop he'd let go of for you
.
"When you are asked if you can do a job, tell 'em, 'Certainly I can!' Then get busy and find out how to do it." - Theodore Roosevelt
Feedback Link - https://www.mcarterbrown.com/forum/b...del-s-feedbackComment
-
i have a couple rails i would trade for that pump milled railComment
-
That's a Taso rail not ptp.Comment
-
I can cut a rail for warp, i could also do that pill milling if that was something you wanted also.BeardedWorks.com (Your Inception Designs and Shocktech Dealer)
BW Youtube
BW Ebay
BW Email
I buy Automags and Mag Parts also.Comment
-
Good to know that this is Taso. See those even less. This is going on a pump, not going up for sale or trade. Than you all for the info and feedback. Going to stay stock.
Comment
Comment