Classic Valve Pressure

[fierymartel]

What tank pressure is everyone running their classic valves at?

[Hellion360]

750-800psi

[Olsson]

850 PSI.

However, I only have two tanks with that output at the moment. If I run more Automags than that during any given day, I have to drop down to 750-800 PSI for the rest of the, which works just as fine.

I haven't noticed any difference in performance, but it feels good to feed my babies with a little higher pressure.

[Chappy]

All your pressure are belong to automag

[fierymartel]

So I should have no issues at 600 psi?

[superman]

It will depend on which bolt you are using.
I am running 575psi out of a hpr on a capped classic valve with level 10 and rt on/off.

I would bet that if you are running 600psi into a classic valve you will be getting shoot down with a level 10 bolt.

[Cdinnova76]

Did running just the RT on/off give an RT effect?

[superman]

Pic for reference.

[fierymartel]

So this suggests that the sidewinder recharges faster than the AGD regulator?

[superman]

It is just a completely different setup than a standard classic valve. It also has additional milling inn the valve.

[fierymartel]

Level 7 bolt

[Cdinnova76]

So been back into paintball and rebuilding some mags. I think 700+ would be fine for a classic valve unless you have an extremely fast trigger finger, ULR, or electro frame. The trigger pull alone makes it tough to get shoot down from my experience. An RT valve will be much higher though. I got zero RT effect at 850psi and went with a 1250? Tank and notice it. I’m far from the most qualified person here so take that for what it’s worth. But if you need a super high pressure regulator ninja is back with theirs for the V3.

Also, powerhouse will make a high output reg if you email them