I’m in the process of finishing up ol Rumple Foreskin and need some good advice on the raw gutted ANS frame I got from Woouulf. Should I buy the brass or nylon tipped screws for the trigger plate, how long, and who makes a thin trigger shoe for these things? I have a McMaster Carr order coming up so gonna toss them in. Thanks!
-
Historically, ANS used nylon but I prefer brass. Just be sure to polish them before installing. As for length, I can't remember for sure but I think it was something around 1/8 or 3/16. It is very possible to go too long, especially for the rear screw. But I want to say 1/8 is about right.
The two thinnest trigger shoes I know of are Shocktech and Nummech. -
-
I think the brass-tipped screws in my Benchmark frames are 1/4" long. A little dab of grease on the screws and the sides of the trigger plate, and the trigger pulls are ridiculously smooth.
I don't think it's going to matter for a paintball gun, but nylon is going to wear faster. Also, in my experience, it's more susceptible to holding on to grit.“It is no measure of health to be well adjusted to a profoundly sick society.” -KrishnamurtiComment
Comment