Official Autococker Picture Thread

[CatFarmers]

[trestles126]

[Walker]

John Gross Pre2k Autococker




The sear lug access hole has been enlarged, and threaded for a plug. Once I got into it, I found that when the original hole was drilled it was a bit off. The hole was enlarged to allow access. Not the way I would have done it, but it works and the plug sits flush and does not impact the bolt. The slot in the bottom of the body, for the lug, was a bit narrow. A little polishing took care of the binding.

The parts:
- Bolt and pin: WGP
- Lower tube: Shocktech, the IVG is non-threaded and came from ANS.
- Cocking rod: AKA for now
- Timing rod: Shocktech
- Frame: Wgp
- Trigger plate: Shocktech
- Sear: WGP roller
- Trigger shoe: Shocktech
- Front block: Meteor with Shocktech pneumatics
- HPR: AKA Sidewinder
- Ball Detent: Shocktech, for now
- Barrel: AKA Javelin

It cycles fine and shoots to field speed....

[trestles126]