WGP Orracle - Need Help

[stealthfox1]

Hi I`m building a new autococker up from the ground and I decided to take an Orracle body. But now a got a few questions....
1) does an Orracle Manual exist, or was it the same like the 2k3 come with?
2) what inlinereg pressure do i need? (btw its a full body, read something about 280psi???)
3) got a leak down the barrel, but vale o-ring is new. Maybe demaged exhaust valve or something else?

thx for answering

[gabe]

1. No manual. It's just a regular autococker so any manual should work
2. Depends on your internals. Most run between 250 and 450psi.
3. Probably the valve o-rings were damaged installing if recently intalled. If not then the cup seal is leaking.

[Hellion360]

1 Same manual as a 2k3 as I recall. Even though it had different pneumatics.
2 This depends on your springing and valve, but 300psi is a good place to start with stock/stock-like internals
3 Definitely change that oring again, make sure your valve retaining nut is tight and your valve set screw on the bottom isn't crazy tight. Chances of needing a new cup seal are low but not 0%

[heyzeus]

3) Did you cock the marker before airing it up?

[stealthfox1]

3) Did you cock the marker before airing it up?

yes sir