Solutions for non-clamping feednecks

[SoKoPaTh]

What are some ways to secure my hopper to my vert feed cocker that has a press-fit standard feedneck on it? Mind you this is a cheap marker and I'm not looking to spend a crazy amount.

[Whee McGee]

If it's too loose, electrical tape. If it's too large, straight elbow. That's about it until you look into replacing the feedneck.

[superman]

have it cut for an empire spec feedneck. Then you can have options like used empire necks, inception, sconi, and others. ultimately your looking at about $100 all said and done including shipping, machining, feedneck.

It really is the best option.

[Magmoormaster]

Nummech can pull the press-fit feedneck and replace with an empire nub for $15.

What I did was dremel in some slits into the feedneck and throw a hose clamp on it. Ghetto but effective. Actually, the feedneck rings in those parts lots I sold you work great for that.

[Jonnydread]

ultimately your looking at about $100 all said and done

That's a lot of money to drop on something that's ultimately a quality-of-life upgrade. I just use a small strip of duct/electrical tape and jam the little bastard in there.

[Mr. Hick]

If you're Dremel savvy you could cut a small groove in your hopper feed necks and run an oring or two.... Much like the old Rico- AK hoppers were set up.