Local Scoop!

[jk88]

Picked these up locally. The black one has a Tadao Yakuza and MQ2(?) valve while the black pro stock has a Zero B board. Anything else cool that you see? I’m just getting back into the hobby after a decade or so.

Can you please help me establish a value? Thank you.

[Magmoormaster]

Both guns have some nice parts on them. Looks like eclipse rams on both, which are worth quite a bit in and of themselves. The red one also appears have an eclipse bolt, also pretty valuable. AKA SCM 3 LPR on the black one.

[jk88]

Thank you

[jk88]

Oh! Did you snag these off the Janesville craigslist! Super cheap for the pair. Well done.

Down in Miami. The pair cost me some money but it helped a friend out.

[Alexndl]

The black mini halfblock 2k3 cocker could be worth north of $600 for the parts alone if the board is good (if not, I would put the zeroB in it since its a MQ valve and buy a E1 for the red cocker)
MQ2 sold in the $250-$300 range
not sure on the value of the tadao board but if it work aroung $150 for the eblade kit (frame and solenoid if the board and screen work)
Eclipse ram could be around $100 and AKA LPR $60? (they can still be found new for $79 plus shipping)
with the half block body bolt and bolt pin around $150


For the red 2k3 around $450-$500 maybe more since it seem to have several aftermarket parts (kapp cocking rod, shocktech beavertail and ball detent, eclipse ram, etc.) and should check the lower tube too to see which valve and hammer is in there.
The back block is nice too.

[jk88]

The black mini halfblock 2k3 cocker could be worth north of $600 for the parts alone if the board is good (if not, I would put the zeroB in it since its a MQ valve and buy a E1 for the red cocker)
MQ2 sold in the $250-$300 range
not sure on the value of the tadao board but if it work aroung $150 for the eblade kit (frame and solenoid if the board and screen work)
Eclipse ram could be around $100 and AKA LPR $60? (they can still be found new for $79 plus shipping)
with the half block body bolt and bolt pin around $150


For the red 2k3 around $450-$500 maybe more since it seem to have several aftermarket parts (kapp cocking rod, shocktech beavertail and ball detent, eclipse ram, etc.) and should check the lower tube too to see which valve and hammer is in there.
The back block is nice too.

thank you. I’m going to probably keep only the black one… do you know what kind of back block is on the red one? It looks kinda odd

[Psycho91]

That might be a ccm back block