Loud cocker mods

[Rainmaker]

I want to make my cocker LOUDER!

I know that an un-ported and short barrel will help. But beyond that, are there any internal mods that would louden her up? A particular bolt style? Parts I can grind/drill out?

[Nish]

Get a loudener.

[VonBraun63]

Add all the stainless and brass you can. That way every time you lift to shoot you grunt.

[Memornix]

That is how I roll. My cockers are heeeeeavy

[JonM]

I recall Ty making a Cocker threaded barrel out of a truck horn. That would certainly do it.

[lew]

Run it on unregulated CO2, in addition to the aforementioned parts.

[lew]

HPA users typically use regulators to bring the pressure- thus noise- down.

[SignOfZeta]

CO2 and an unported 6” barrel will work wonders. Also, be sure you have negative clearance at your back block, snap slap slap.

[lew]

You can always install a helicoil when the pump arm threads strip out!

[OpusX]

I mean you could 3d print a freak tip that is also a loundener.....but what do i know.....

[SignOfZeta]

Or you could drive to Target, buy a bicycle horn, take it home, cut it in half in the correct spot to friction fit over any barrel, and have a nickel plated paintball blunderbuss that would probably project better than lumpy soft plastic and have it in half the time it takes to 3D print one.

[latches109]

Ive found the larger the valve hole the louder it gets. Also, fashion a bike bell to the back so that every time the back block moves it will ring.

[BenoitOWN]

Use the rolls for cap gun :P
figure out the feeding system.

[BrendanB]

just get a solo barrel tip.