Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
I purchased a Slice Pump kit for my Vengeance AutoCocker. I installed it and when I aired it up, it was leaking from the front. If I tighten it, it does not align properly. Can anyone shed some light on what I need to do to fix it.
Dont know how slice pump kit is assembled, most have a oring to prevent leak but have you tried 3 wrap of teflon tape around the thread before you screw it on the front of the body?
Replace the o-ring, as others have mentioned. The "block" is not rigidly attached to the rod, just hold it as you tighten the rod to prevent it from spinning.
Comment