Prostock LPR

[Criticalhammer]

Does anyone know what the max input pressure for a WGP prostock LPR is?

[JohnB]

Like the valve? I didn’t think it had a lpr in them. I like tank reg at 300-800 (300-500 personally) and the hpr around 280 psi I think.

[JohnB]

I was thinking pump cockers; never mind I know nothing about front pneumatics

[JohnB]

It is a bell curve, so should increase until you hit peak and then decrease velocity as you go higher. So like I am guessing 280-330 would be the sweet spot. Above that the valve wouldn’t open long enough. A proper tech could confirm specifics I imagine.

[Schultz98]

My old ebolted tippmann had a cocker LPR on the ASA and took straight tank pressure. The reg I used was able to bring it down from 850 down to safe pressures for a timmy solenoid(~60psi?). I would love someone else to confirm, but I think your prostock lpr will handle 850psi.

[Magmoormaster]

Does anyone know what the max input pressure for a WGP prostock LPR is?

Just to clarify, are you asking what pressure the prostock LPR can take going in, or how high it is able to put out? You said input, so I'm assuming the former but I want to make sure.

If you are asking the former, it'll take full tank pressure (800 PSI) just fine. Not sure how much higher, but I'd assume 1800 (based on general paintball standards). If you are asking the latter, I have no idea haha. I'd guess about 200 PSI.

[Jordan]

Mine never liked full tank pressure, they'd creep at 850-900 psi input.