Marker upgrades.

[himurax13]

Other than upgrading the oem reg seat with a Dye version and adding a barrel kit, has there been any other attempts for aftermarket upgrades?

Will the lightning valve for the Spyder fit? Has anyone tried a Spyder Spring kit? What about the Tech T Paintball Zero Kick hammer for Spyders? Has anyone polished the surfaces where the sear and hammer meet?

Sent from my SM-G970U using Tapatalk

[TKcustoms]

Depends what azodin you have, a kd3 will have less available upgrades than a kaos 2.

I have the TechT hush bolt w/o the front oring and it did help my consistency in my blitz. I had a spyder spring kit in a kp2 project marker but wasn't too impressed with the performance so i removed it. I preferred the zero upgrade over messing with spring kits.

You could always message or email TechT to see if those parts would fit.

[Meleager7]

on the topic of non-existent Azodin upgrades, I've always wonder why neither Azodin , or anyone else has whipped up a KP3 autococker front block, and a matching slider frame!? their KP3 pump is a sweet half block cocker , just waiting to come to life !

[Toestr]

The lower tube is 11/16 nominally. Any 11/16 cocker valve should work for a pump and any Spyder valve should work with a blowback. The only potential problems are a) tolerance stacking; b) valve length may not allow for full bolt/hammer travel; and c) the retaining plug may not work with the hole in the bottom of the valve due to size/depth.