When I pierce a fresh 12 gram I get a “slow” leak down the barrel (takes about 10-15 mins to drain a 12gram).
Using a ICD lever changer, not sure if that matters.
Using a ICD lever changer, not sure if that matters.
-
Check your cup seal. -
And if that’s not the culprit check the oring on your powertube assemblyComment
-
Down the barrel eh? Must be the cup seal I reckon.💀 PK x Ragnastock 💀Comment
-
This is what happens when I start to reply then get distracted, what Arctic said.💀 PK x Ragnastock 💀Comment
-
You can flip the cup seal in a pinch and get another 10+ years out of it if the seal is bad. But most likely it just loosened up on you. A lil light hold locktite in the brass piece that holds the cup seal will keep it from backing off on you again. It can loosen up on you over time if you don’t. You could use a small bit of Teflon tape if you don’t have thread locker but I prefer the thread locker especially when dealing with CO2 and oils.Comment
-
Thanks, Chuck. I’ll keep this in mind for the next one! I ordered a handful of cup seals. This one was shot to the point of virtually non-existent.
I’ll see you on the beaches Saturday!! Rumor has it you’re going to be shooting the wrong direction again….just like at HOTH! 😁Comment
Comment