Vertical air source hard to get off.

[Prometheus]

I can’t seem to screw off the Stock Puncture Adapter Assembly part of the bucket. Anyone have any recommendations or tricks?

[Chuck E Ducky]

It takes an Allen key in the end. A big one. It will just spin off.

[Chuck E Ducky]

Oh in a pinch you can double up keys to fit the size you need if you’re set don’t go big enough. Shouldn’t need much torque to get it off. There just isn’t a place to grab it good other than that key hole.

[Prometheus]

Not sure I understand where you’d put an Allen key? I’m not home currently. But basically the 12g holder screws off but the part that screws into the asa to the 12g is stuck.

[Carp]

If you turn the marker upside down and look at the pierce pin/seal area. There is a giant hex key shape. 😉

[Prometheus]

Got ya! Will check it out when I get home 😬

sounds like I need to swoop up a big Allen key.

[Carp]

Almost positive, a 3/8 hex key, is what you'll need. 😉

[Prometheus]

Thanks for the replies!