Yakuza USB NT board options.

[autococker04]

Hey everyone, I picked up a dm11 in a gear bag sale and thought I lucked out when I saw the upgraded board. Unfortunately, the oled screen doesn’t work and I don’t have a cable for the board.

After some research, it seems like this was a pretty common problem with these and the company basically didn’t care.

does anyone know of a solution or workaround? I’d like to be able to cap at 5.5 bps, but the stock board won’t and the link I found to the todao software is dead, so even if I plugged it in I’d be out of luck.

[powpowpaintball]

I have one and used it with the screen dead, but I was fine with the settings that were already input. If you aren't able to make it work, UL boards can be found pretty readily at reasonable prices.

[autococker04]

I have one and used it with the screen dead, but I was fine with the settings that were already input. If you aren't able to make it work, UL boards can be found pretty readily at reasonable prices.

I might end up going the UL board route, it’s set to what sounds like the old school 15 bps ramp. Not a lot of places appreciate that any more haha