Cs1 front grip gap. Advice

[Levirate]

I just bought this cs1 off of eBay, cleaned and repaired it, and made sure it held air. Haven’t run any paint through it yet. After I put it back together I noticed that the front grip has a gap between the main body and the grip covering the batteries. Im not sure if it’s the wrong grip, or if the battery pack is wrong. 25543362-2ED8-4331-88D9-AF540E427362.jpeg B191E2D3-06AF-48C2-82B4-90D0266F6A22.jpeg

[Blackmagic71]

This might sound dumb - but on my CS1 I have to give the battery cover/fore grip a moderately firm thump to get it to seat all the way. I normally hold the trigger frame in one hand and strike the base of the foregrip against my palm.

[Levirate]

Thanks for the suggestion, tired it and it doesn’t want to go any further then it is

[Chuck E Ducky]

Push harder make sure the tabs are inside the frame. Unless the grip is damaged.

[Levirate]

The grip does not appear to be damaged, and I’ve tried to push it harder to get it to where it needs to be.

[ford]

Is the Geo4 grip the same as the CS1? Maybe I'm crazy but the grip doesn't look right to me.

[Levirate]

Do you think the grip is a geo four grip and not a Cs1?

[Chuck E Ducky]

Looks like a CS1 grip to me. Maybe check the orientation of the battery pack. I’m not sure if it can be reversed or not. I have never needed to remove my CSR battery housing.

[Levirate]

Ok thanks, I’ll look at that.