Battle Tested BT SA-17 o-ring sizes

[Chandlercv]

Description	Dash size	OD	ID	CS	Hardness	Material	Notes
Hammer	-016	3/4	5/8	1/16	70A	Urethane	In player parts kit, it is blue
Valve	-016	3/4	5/8	1/16	70A	Urethane
Puncture Pin Housing	-016	3/4	5/8	1/16	70A	Urethane
Feed Tube Cap	-016	3/4	5/8	1/16	70A	Buna
Bolt	-015	11/16	9/16	1/16	70A	Urethane
Rear Block	-015	11/16	9/16	1/16	70A	Buna
Adapter Plug	-015	11/16	9/16	1/16	70A	Buna
Feed Body	-015	11/16	9/16	1/16	70A	Buna
Barrel		3/4	11/16	1/32	70A	Buna
Seal Housing Inner	-014	5/8	1/2	1/16	70A	Urethane
CO2 Puncture Seal		13/32	5/32	1/8			Square profile, suspect it is urethane

[XEMON]

Here is the pierce pin assembly:


Don't remember who was looking for it, but here are the dimensions of the 12g seal:

[Chandlercv]

After a lot of experimentation with puncture sea replacements, I can report the following:

- 3d printing seals to Xemon's specification using CraftCloud's Elastic Resin (https://craftcloud3d.com/material-guide). This material immediately blows out.

- Using a -201 o-ring without the smaller retaining ring seems to work well enough. It survived two CO2 changes in garage testing.

Next up, field testing. If anybody can report back any experiences with alternatives before I do, that would be appreciated.