Build Log M10L 2529

[BretG]

We haven't posted for a while, but we've been busy with a lot of rebuild projects putting our MSP valves and components in old Sheridan KPs, PMIs, and PGPs.
This however is a new build. A G&H M10L stainless steel pirate lever. The body is a PGP type stacked K tube set in a black walnut pirate stock with a large loop lever, a 12 gram cut out with a lever changer and a feed gate on the top magazine tube. It also has our Magnum SP valve, the stainless trigger and RVA back block and is the first project to have the new marking system dot peener used. Double nubbin detents are used for the breach and barrel.
We like to take projects that challenge us in new directions and this one sure did. It shoots fantastic and we hope its owner does great with it.

[Jonnydread]

I love the marker to loop ratio on this

[JeeperCreeper]

Short and sweet.

[Jimmydee]

All of you post wicked ass builds but I want to see videos of these shooting, especially this one

[sonixr7]

I would like to add that this is KL53. The large loop lever allows me to grab the bottom off the lever with my pinky, ring, and middle fingers to pull down instead of push down with the top of those fingers.

[sonixr7]

Comparison between M10L and M15L both in pirate stocks.

M10L is noticeably lighter to hold up with one hand.

I like the lighter shade stock on the M10L that it came with.

[sonixr7]

Comparison between M10L Pirate Stock and M15L Full Stock.

[sonixr7]

Comparison between M10L, M15L, and M20B.

[BretG]

Excellent pictures! Thanks for posting them.
Nice to see a family picture.

[sonixr7]

Thank you. I wish I was a better photographer to capture the beauty and scope of these magnificent pieces.