Front block questions

[XEMON]

Hello MCB,

I'm looking at the Inception body for a project, and I have some questions ...

I am mostly looking at the Horner body.

The pictures shows the front block incincluded. Is it removable? Can I use any front block I want?
also is it possible to have internal air line with air through grip frame (I would like to not have the reg/handle on the front)?

This is for a 2K+ spec pump kit, I have not picked a frame yet.

Thanks
X

[Super69ur]

Most front blocks should work. Gas-through the grip would require custom machining and installation of a regulator somewhere. Easier to just buy a Nummech frame.

assuming you have a VASA hole in the hornet body.

[Tracker]

all of the inception design guns are set up like mini cockers, which means you will need to provide air to the valve somehow which is done typically via the front block, not all front blocks have the 1/8ths NPT threaded hole on the bottom, most do,
there are other options, but it will require putting some kind of a hole somewhere it wasnt originally designed to be

[XEMON]

Thanks for your help everyone.
it looks like it may not work too well for my project unless I drill the bottom of the body between the frame and where the front block would be ... My pump kit does not have an asa built in, it's design for full body.

How much room is there between the front of the frame and the front block?
They look pretty long, could they be converted to have a standard cocker VASA at the standard location?

[Knuckle Dragger]

I don’t see why they couldn’t be drilled for a VASA, but the VASA you get or have may not be aesthetically pleasing if the body is narrower than a WGP. Might be worth getting a pump kit from Inception to go with your new body. As Super69ur said, Nummech has a gas -through frame with the option of no fore grip, but you’ll need holes drilled under the body where a VASA would normally be.