Long story short my resurrection barrel kit front was ran over by a truck. What would it take to convert a inception design barrel front to fit a resurrection barrel back?
-
-
Buy a new ID barrel front and back -
its similar in design because they were both designed by the same guy, but not similar enough to allow for that, you need to bore out the resurrections barrel deeper, and thats just as likely to cut the whole front end of the barrel off..
contact inception, explain it got run over, see if they will give you a break on a replacement, they might be able to help?Last edited by Tracker; 04-04-2023, 11:02 PM.Comment
Comment