Kingman Chaser 11mm Pistol Disassembly

[Cdn_Cuda]

In amongst a few markers Jimmydee had sent my way was a Kingman Chaser 11mm Pistol. So figured I might as well take it apart!

IMG_2542.jpg

Remove the grip frame first:

IMG_2545.jpg IMG_2546.jpg


And the you can see the bottoms of the marker:

IMG_2544.jpg

[Cdn_Cuda]

Then I move on to the slide assembly. Removing the plate on the slide exposes the cocking rod

IMG_2547.jpg

Undoing a screw in the slide allows you to remove the top slide section.

IMG_2548.jpg

There is a spring to all the slide to reset after the marker is cocked:

IMG_2550.jpg

And you can see the bolt section that is the actual cocking mechanism:

IMG_2549.jpg

[ChoSanJuan]

Great stuff! Thanks for doing this, was planning on doing this since I've got 3 hanging around.

[Cdn_Cuda]

And here is the hammer portion removed from the body:

IMG_2551.jpg

Now moving back to the bottom of the marker, we can see there’a an easily removable metal piece that takes the force of the hammer. This piece just slides right out.

IMG_2552.jpg IMG_2553.jpg


Then there is the breech block, if you will, the black plastic section that where the mags feed into the full breach:
IMG_2554.jpg
IMG_2555.jpg

[Cdn_Cuda]

So here are the entire removed internals:
IMG_2556.jpg

The value is accessed behind the black plastic breech block. Slotted screwdriver removes the cover and allows you to removed the valve pin and spring.

IMG_2558.jpg IMG_2557.jpg

[Cdn_Cuda]

The rear internals connect like a standard Spyder, with the bolt attaching to the lower hammer. The hole in the lower hammer is where the cocking rod connects.

IMG_2561.jpg

And here’s a look at the bolt itself. It even had detent cutouts.

IMG_2560.jpg IMG_2559.jpg

[Cdn_Cuda]

And finally, the grip frame where the mags feed into and 12g go. I have no mags.

IMG_2562.jpg IMG_2563.jpg

[Cdn_Cuda]

Overall a neat marker. Has some good features like the hidden cocking rod, the slide to cock. Too bad a full sized marker doesn’t integrate some of these ideas. Now airs up and no leaks.

[Cdn_Cuda]

ChoSanJuan valve oring was toast.

[ChoSanJuan]

Haven't run into that yet. You think that's a common failure point?

[Cdn_Cuda]

Likely. Kingman has never been known to have the greatest orings. Every time I take a Spyder apart the orings are jelly.

[Trbo323]

Oh! I've had one of these, they are pretty cool. I had hopes I could get a bunch on the cheap just so me and the guys could mess around in the yard without having to pull out 68 Cal stuff but people apparently like them too much and I couldn't get any for under about $60. The magazines were hard to find as well. Shame, I like the design

Sent from my motorola edge 5G UW (2021) using Tapatalk

[ChoSanJuan]

I have 3 because the mags are so unobtanium. I got a good working one, saw one for cheap on our favorite discount auction site thinking it would be for parts. Nope, it worked. Then couldn't resist with someone selling a hammer and threw in another one for a nominal price. So I've got 3 mags for 3 chasers.

Le sigh...